Excalibur AL-1650-EDPB Guía de instalación descargar pdf (Pagina 2)

Installation Considerations

BEFORE ST

ARTING THE INST

ALLATION, READ THIS ENTIRE MANUAL

TO FAMILIARIZE YOURSELF WITH ANY INSTALL REQUIREMENTS

BE SURE TO VERIFY EACH CIRCUIT WITH A DIGITAL MULTIMETER•

IDENTIFY WHICH CIRCUITS ARE REQUIRED FOR THE VEHICLE IN

•

QUESTION

MOUNT

ANY SYSTEM COMPONENTS AND ROUTE WIRING AWAY

•

FROM MOVING P

TS OR PARTS OF THE VEHICLE THAT

GENERA

TE EXCESSIVE HEA

TAPE OFF OR REMOVE ANY UNUSED WIRING TO PREVENT

•

POSSIBLE SHOR

CIRCUITS

ONLY ACTIVATE THE REMOTE START FUNCTION IN A WELL

•

VENTILA

TED ENVIRONMENT

AFFIX

THE UNDERHOOD WARNING STICKER•

AVOID ANY AIRBAG CIRCUITS, USUALLY INDICATED BY A YELLOW

•

SLEEVE OR JACKET

AROUND THE WIRING

6 Pin Main W

ire Harness

RED & RED/WHITE WIRES - CONSTANT POWER (+) INPUT

Most of the main wiring harness connections are high amperage circuits so high reliability con-

nections must be made� It is recommended to solder and adequately insulate each connection�

Many of these connections are made at the vehicle’s ignition switch so be sure to properly route

the harness away from steering wheel tilt mechanisms or anything that could compromise the wire

insulation� Remember, the goal is for this system to mimic the ignition switch� Keep this in mind

when deciding which ignition & accessory circuits to power� Most, if not all will be required�

REQUIRED� These wires provide the constant positive 12v power supply for the system’s

operation� CONNECTION: Connectthesetoaconstant+12voltsupplywithsufcientamperage

for remote starting� The +12v power supply to the ignition switch is ideal� Some vehicle’s have

lowamperageignitionswitchesinwhichcaseyouwouldneedtondapowersupplyatafuse

block or at the vehicle’s battery� Be sure these wires are fused within 6 inches of the connection

to the vehicle� The two 30AMP

fuses in the harness are to protect the system module, NOT THE

VEHICLE

� Their use is REQUIRED� It is ideal to have a separate supply for each wire but, if the

chosensupplyissufcientenough,youcancombineboththeRED&RED/WHITEwiresatthe

same point�

PINK WIRE - IGNITION #1 (+) INPUT/OUTPUT

REQUIRED� This connection is required and is critical to the operation of the system� It is

an “IGNITION ON” input when the ignition key is turned on� It is also the primary ignition output

for remote start operation� It turns on when remote start is activated and stays on during engine

cranking for the entire remote start sequence�

CONNECTION: The vehicle’

s primary ignition circuit is typically found at the ignition switch

� The

proper circuit will show +12v when the ignition key is in the ON/RUN and ST

ART positions

�

1 2 3 4 5 6 7 ... 13 14

Comentarios a estos manuales

Sin comentarios

Excalibur AL-1650-EDPB Guía de instalación Pagina 2

Comentarios a estos manuales