Excalibur AL-1650-EDPB Guía de instalación descargar pdf (Pagina 5)

18 Pin Secondary Wire Harness (cont’d)

RED/WHITE WIRE - TRUNK RELEASE / 2ND CHANNEL (-) OUTPUT

This output provides a 250mA negative output when the trunk release/CH2 function is activated

by the controller� The output will remain as long as the controller button(s) is held�

CONNECTION: Connect this wire to the vehicle’s existing trunk release switch if it is a low current

negative circuit� If the circuit is a high current ground or a positive circuit, the use of a relay is re-

quired

� NOTE: The built-in horn relay circuit can be programmed & utilized for trunk release

if not being used otherwise�

BLACK/RED WIRE - LIGHT RELAY N/O (+/-) INPUT

Thiscircuitprovidestheconstantfeedinputforthebuilt-in10ampdomelightrelay.Specically

the normally open pin (pin 87)� This relay can be programmed via installer feature #2 for LOCK,

IGNITION, or ACCESSORY if need be�

CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen

function�

GREEN/VIOLET WIRE - LIGHT RELAY COM OUTPUT

Thiscircuitprovidestheoutputforthebuilt-in10ampdomelightrelay.Specicallythecommon

pin (pin 30)� This relay can be programmed via installer feature #2 for LOCK, IGNITION, or

AC-

CESSORY if need be

�

CONNECTION: Connect this wire to the vehicle circuit chosen to be driven� By default, connect to

the vehicle’s domelight circuit�

WHITE/RED WIRE - LIGHT RELAY N/C INPUT

Thiscircuitprovidestheinputforthebuilt-in10ampdomelightrelay.Specicallythenormally

closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be

programmed via installer feature #2 for LOCK, IGNITION, or

ACCESSORY if need be

�

CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen

function�

VIOLET/BLACK WIRE - HORN RELAY N/O (+/-) INPUT

Thiscircuitprovidestheconstantfeedinputforthebuilt-in20amphornrelay.Specicallythe

normally open pin (pin 87)� This relay can be programmed via installer feature #3 for UNLOCK,

TRUNK RELEASE, or PULSE AFTER START if need be�

CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen

function�

BLUE/BLACK WIRE - HORN RELAY COM OUTPUT

Thiscircuitprovidestheoutputforthebuilt-in20amphornrelay.Specicallythecommonpin

(pin 30)� This relay can be programmed via installer feature #3 for UNLOCK,

TRUNK RELEASE,

or PULSE AFTER START if need be

�

CONNECTION: Connect this wire to the vehicle circuit chosen to be driven� By default, connect to

the vehicle’s domelight circuit�

BROWN/BLACK WIRE - HORN RELAY N/C INPUT

Thiscircuitprovidestheinputforthebuilt-in20amphornrelay.Specicallythenormally

closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be

programmed via installer feature #3 for UNLOCK,

TRUNK RELEASE, or PULSE AFTER START if

need be

�

CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen

function�

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comentarios a estos manuales

Sin comentarios

Excalibur AL-1650-EDPB Guía de instalación Pagina 5

Comentarios a estos manuales